You are here:home > Industry news > Pruduct's Detail
The high frequency heating the material used to
High-frequency diathermy
To do a simple introduction in this regard
The sensor consists of the following parts:
1, the contact plate: also known as the bus, the two coil is connected with front end and the quenching furnace transformer it, rear end and the effective coil welded together. Two pieces of the contact plate there aresy mmetrical, the current loop, the insulation plate with mica plate manufactured between two contact plate.
2, cooling water box: each contact plate welding a cooling water box, contact with cooling plate.
3, the contact plate fastening bolt: insulation board using the two fastening bolts and the two contact plate, boltwith brass rod to manufacture, use and bakelite washer and a bakelite casing, the insulating bolt and the contact plate. If the contact plate when the temperature is nothigh, the fastening bolt available nylon manufacturing.
4, a positioning ring plate: fabric manufacturing, used forclamping and positioning ring, so as to be insulated from the sensor body.
5, a positioning ring: for quenching parts of the axial positioning and radial limit, when the six party componentsat the top of the cap on the locating ring, to ensure that the axial parts quenching zone distribution accurately.
6, plate fastening bolt: used for pressing and sensors onthe flange between the fastening, ensure the positioningring location accuracy.
7, the flange: made of copper, welding and effective coiland the water jacket, so as to form a quenching water cavity, and positioning fixture of Ch.
8, effective circle: to form a magnetic field, and themagnetic field directly for conductor heating workpiece is called the effective coil or conductor, if effectiveconductor is a copper tube can also be called the effective wire. It and the contact plate is firmly welded together.Henan Chao Feng electrical equipment limited company is morerefined sensors of various types
9, the quenching water: its full name should be thequenching water inlet pipe, quenching water through it into the quenching water cavity, quenching water pipe and thewater jacket is welded together.
10, the quenching water: when the parts are heated toquenching temperature, quenching water quenching water into the quenching water cavity, then from quenching water spray out, make parts quenching.
The 11, sensor positioning hole: drill in the contact platesurface, when the sensor installation, fixed bolts quenched transformer two coil out from the fixed Kong Shen, tighten the nut, ensure the contact plate and the transformer coilcontact plate good level two.
12, cooling water pipe: with high frequency furnace
Welding in the cooling water box, a.
13, the limiting plate on the lower end of the parts: radiallimit.
Believe to pass the introduction of above we can more deeper understanding in detail Henan Chao Feng electrical websitehttp://www.cfjrsb.com
Tags: on-product information